[Rom23]

check engine, abs and chasis stabil just randomly came on when i got in the car this morning low tire been on anyone know what it could be?

[LA1Z24]

Yes, let me just peer into my magic 8 ball and pick 1 code of the possible 2000 that it could possibly be.

[F22Cam]

All of these lights came on at once after no prior errors ?

[Rom23]

Originally Posted by F22Cam

All of these lights came on at once after no prior errors ?

yea beside the low tire

[Rom23]

Originally Posted by thejeremyman9

Hes right in saying it could be anything... You need to scan for codes to figure it out. The warnings on the dash don't narrow it down at all.

bro i dont got time to get it scanned rn i was just tryna see if anyone had the same issue before…

[F22Cam]

Originally Posted by Rom23

yea beside the low tire

Interesting, I’ve never heard of this before.

Definitely seems like it’s gonna be a job for a shop. Good luck

[Rom23]

Originally Posted by F22Cam

Interesting, I’ve never heard of this before.

Definitely seems like it’s gonna be a job for a shop.

word i hope not some one said it could be wheel speed sensor but im bout to find out tomorrow

[delaineyklein]

Is it tuned? I have the same issue rn

[Rom23]

Originally Posted by delaineyklein

Is it tuned? I have the same issue rn

yea it is

[delaineyklein]

Originally Posted by Rom23

yea it is

when was the last time you flashed it ?

[Rom23]

Originally Posted by delaineyklein

when was the last time you flashed it ?

last year

[delaineyklein]

Originally Posted by Rom23

last year

mb i didn’t see what you said about not being able to scan it. your best bet is to go fill up your tires and reset your tpms, i can see your light is on. i’d look into getting a code reader if the chassis stabilization stays on. i linked the one i have below, it works great and reads both the DME and DTC codes. even if it’s just the tpms, there’s a possibility the chassis stabilization will stay on until you manually clear the codes in the DTC. you can try to put it into sport/ eco while you’re driving to see if the cars being fr or not.

i don’t reccomend you take it to get diagnosed yet. my wheel speed sensors fried themselves after flashing and didn’t give me any issues, despite showing up in the DTC. took it to some local places and the dealer, they were no help until the car bricked the trans months later.


Creator C410
https://www.amazon.com/Creator-Scann...Y2hfYXRm&psc=1

[Carastafari_MJ]

Originally Posted by Rom23

check engine, abs and chasis stabil just randomly came on when i got in the car this morning low tire been on anyone know what it could be?

Originally Posted by thejeremyman9

Hes right in saying it could be anything... You need to scan for codes to figure it out. The warnings on the dash don't narrow it down at all.

Originally Posted by delaineyklein

mb i didn’t see what you said about not being able to scan it. your best bet is to go fill up your tires and reset your tpms, i can see your light is on. i’d look into getting a code reader if the chassis stabilization stays on. i linked the one i have below, it works great and reads both the DME and DTC codes. even if it’s just the tpms, there’s a possibility the chassis stabilization will stay on until you manually clear the codes in the DTC. you can try to put it into sport/ eco while you’re driving to see if the cars being fr or not.

i don’t reccomend you take it to get diagnosed yet. my wheel speed sensors fried themselves after flashing and didn’t give me any issues, despite showing up in the DTC. took it to some local places and the dealer, they were no help until the car bricked the trans months later.


Creator [...]

Hey I am new to this forum and i currently drive a bmw 320i 2012, I had the same problem about my abs stabilisation it keeps appearing on the dashboard but disappears when i shut off the engine and turn it back on. it jus recently stopped showing up after i filled up my tires w air although tires are full, bc i also got a warning saying my tires sensor arent reading but after doing that those two problems i had jus disappears

[DreamerJoe]

Originally Posted by Rom23

bro i dont got time to get it scanned rn i was just tryna see if anyone had the same issue before…

Scanning takes like 30 seconds, if you don’t have a scanner Autozone used to scan for free. If they do just write down the codes and post them. Not possible to take a guess just off of those pop up’s.. I can certainly tell you you’re tire pressure is low though 🤷‍♂️

[DreamerJoe]

Also just saw your post about being tuned, MHD ir BM3? Both have the ability to scan for codes

[n55david]

Originally Posted by Rom23

bro i dont got time to get it scanned rn i was just tryna see if anyone had the same issue before…

😆 🤣 😂 😹
It can be a hundred things man.. without codes nobody can help you at all. It might be the battery, might be a sensor, might be a wire, might be etc etc etc etc and etc.. and etc and etc.. and another 30 causes.. or, could be a different 5 things.. OR it could be something else, or even something else.

Fucking scan the car man.. it's literally the only way to try and guess.

[LA1Z24]

Originally Posted by n55david

😆 🤣 😂 😹
It can be a hundred things man.. without codes nobody can help you at all. It might be the battery, might be a sensor, might be a wire, might be etc etc etc etc and etc.. and etc and etc.. and another 30 causes.. or, could be a different 5 things.. OR I could be something else, or even something else.

Fucking scan the car man.. it's literally the only way to try and guess.

He don't got time for that man!

[n55david]

Originally Posted by LA1Z24

He don't got time for that man!

Oh.. my bad

OP.. it's the rod bearings.. you spun them

[F22Cam]

Originally Posted by LA1Z24

He don't got time for that man!

Yo I’m crying 😂😂😂

[DreamerJoe]

Originally Posted by F22Cam

Yo I’m crying 😂😂😂

That’s 30 seconds too long man